关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:电机通风板冲槽模结构与优化设计
作者:张宏飞
2016年第5期 访问次数:228次

摘要:通过对电机通风板冲裁工艺分析,针对冲槽模中完成冲通风槽容易出现槽数不够,槽口开裂,不平等难题,制定了合理的设计改良方案。介绍了模具结构设计中的一些特点,对试模过程中出现的上述难题作了深入分析并提出了相应整改措施。该模具在冲裁工艺及关键零件的优化设计方面的特点,可供类似零件的模具设计作参考。
关键词:通风板;冲槽模;结构;优化
Abstract: Through analysis of  motor ventilation plates punching technology, aiming at solving the problem in the punching-the number of slots is not enough, notch crack, notch Uneven , formulate a reasonable technical solution. In this paper, the characteristics of die structure design were introduced, and some problems in the process of testing were analyzed and the corresponding improvement measures were put forward. The characteristics of punching process and optimization design of key parts can be used for similar parts molds design reference.
Key words: ventilation plate; punching die; structure; optimization
 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码