关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:用于微飞轮的永磁平面微电机多目标优化设计
作者:吕允春,白 越,吴一辉
2009年第12期 访问次数:220次

摘  要:考虑到尺寸效应对永磁电机磁、热性能的影响,给出了一种用于微小动量飞轮的无铁心无刷永磁平面微电机的多学科设计方法,即利用多学科优化软件iSIGHT之有限元分析软件Ansys对电机进行多学科设计优化研究,以电机质量、气隙磁密、绕组损耗为优化目标,以几何尺寸、转动惯量等要求作为约束条件进行优化计算。通过多学科设计优化,电机质量减小了28.3%,气隙磁密增加了2.9%,绕组损耗减小了2.6%,提高了设计效率,在永磁微电机的设计中具有现实意义。
关键词:微飞轮;永磁电机;有限元法;多学科协同设计优化
 
Abstract: A multidisciplinary design method of coreless brushless permanent magnet planar micromotor used for minimal momentum flywheel was given considering influence of size effect on magnetic and thermal properties of permanent magnet micromotor.The software of multidisciplinary design optimization(iSIGHT)and the software of Finite Element Analysis Software(ANSYS)were applied to optimize the micromotor.The mass,flux density and wingding power consumption of the micromotor were the optimization goal,magnetic field,temperature and other requirements were the constraint condition.The results of optimization indicate that the mass of the motor is reduced by 28.03%,the flux density is increased by 2.9%,and the wingding power consumption is reduced by 2.6%.This method will raise the design efficiency and have practical significance to design of permanent magnet micromotor.
Key Words: Micro flywheel;Permanent magnet motor;Finite element method;Multidisciplinary design optimization
 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码