关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:永磁同步电机电感参数测量系统的设计与分析
作者:曹艳玲,文彦东
2013年第12期 访问次数:212次

摘要:基于稳态电压方程,提出一种永磁同步电机直交轴电感参数的工程化测量方法。首先利用功率分析仪测量电机相电压,消除逆变器内部IGBT导通压降及PWM信号死区的影响,并通过定子电阻、永磁体磁链与温度关系的测量,消除温度的影响,然后利用单片机对电机相电压、电流及位置信号进行同步采样,计算dq轴电压和电流,最后通过稳态电压方程获取电感参数。试验结果表明:该方法消除了IGBT导通压降、死区及温度等因素对测量结果的影响,它能够准确测量不同电流幅值和磁饱和情况下直交轴电感参数,而且适用于不同结构的永磁同步电机。

关键词:永磁同步电机;转矩控制;直轴电感;交轴电感
Abstract: Based on the steadystate voltage equation, an engineering dq axis inductances measurement method was put forward for permanent magnet synchronous motors. First, the line voltage was measured through the power analyzer to eliminate the influence of PWM signal deadtime and forward voltage drop of IGBT, and the temperature dependence of both the stator resistance and the flux linkage were measured to eliminate the influence of temperature. Then, the microcontroller sampled the voltage, current and position signal synchronously and calculated the dq axis voltage and current. Finally, the dq axis inductances were computed from the steadystate voltage equation. The experimental results illustrate the method eliminates the impact of voltage drop of IGBT, PWM signal deadtime and temperature. It can accurately measure the dq axis inductances under the different current and magnetic saturation, and can be applied to different structure permanent magnet synchronous motor.

Key words: permanent magnet synchronous motor; torque control; daxis inductance; qaxis inductance

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码