关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:永磁同步电机对拖试验电压降低问题研究
作者:康尔良,肖子阳,赵鹏,等
2015年第8期 访问次数:245次

摘要:大型永磁同步电动机(PMSM)对拖做负载试验时,由于作为发电机运行的PMSM端电压随负载电流增加而降低,端电压低于负载回馈的电网侧电压导致无法继续加载的问题,本文提出永磁同步发电机输出端并联电容器的方法,以补偿因电机感性回路中滞后的无功电流导致的发电机端电压下降。根据发电机定子绕组电流计算直轴去磁电流Id,定量计算无功补偿的电容值,既可以满足PMSM加载的需求,也可以避免投入电容量过大导致发电机端电压过高对电机绝缘材料寿命的影响;建立了带电容补偿的PMSM对拖测试的仿真模型。仿真结果表明,电容补偿值计算正确,能有效升高发电机的端电压,实现PMSM的平稳加载。与其它加载方法相比,该方法工程造价低,并能够实际应用于PMSM的性能测试。
关键词:永磁同步电动机;对拖试验;电容补偿;仿真
Abstract: As the terminal voltage of permanent magnet synchronous motor(PMSM) running as the generator decreases with the load current increasing during the large permanent magnet synchronous motor backtoback connected dragging for the load test, it will not be able to be loaded when the terminal voltage is lower than the gridside voltage under the load feedback. In this paper, proposed an approach to make sure the capacitor and the output of permanent magnet synchronous generator were in paralleled, so the voltage reduction of the generator resulted from the lag of reactive current in the motor perceptual loop can be compensated. It can satisfy the need of loading and the lifetime of generator insulation material would not be influenced by the overtopped terminal voltage of generator in the case of large capacitance after the direct axis current demagnetization Id was calculated based on stator winding current of the generator and the capacitance reactive compensation was figured up, then simulation model of PMSM dragging test with capacitance compensation can be built. The simulation results show that the calculation of capacitance compensation is correct, so the terminal voltage of generator can be improved effectively, and the PMSM can be loaded steadily. The method in this paper has an advantage of low cost compared with other methods of loading, and can be used in the performance test of PMSM in practice.
Key words: PMSM;backtoback test;electric capacity compensation;simulation
 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码