关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:无刷直流电机无位置传感器控制新方法与实现
作者:任志斌,温路佳,许斌,等
2019年第3期 访问次数:246次

摘要:无刷直流电机的无位置传感器的控制通常采用反电动势法,但此方法存在滤波电路造成相位滞后、启动时反电动势检测困难、重载时换相续流的影响等问题。该文章提出一种根据非导通相端电压检测,无刷直流电机的无位置传感器直接换相方法。该方法克服了传统反电动势法存在的诸多缺陷,提高了换相的准确性,实现了无刷直流电机无位置传感器控制的直接换相。通过理论分析得出换相时非导通相端电压变化情况并进行了深入的研究。经过实验与研究,验证了该方法的可行性。
关键词:无刷直流电机;无位置传感器控制;非导通相端电压;直接换相
Abstract: The control of brushless DC motor with no position sensor usually adopts the backEMF method, however, this method has some problems such as filter circuit leading to phase lag, difficultly to detect the counter backEMF at startup,the influence of the commutation freewheeling during heavy loads and so on. This paper proposed a methed of brushless DC motor with no position sensor to direct phase which based on nonconducting phase terminal voltage detection. This method overcomed many defects existing in the traditional backEMF method, improved the accuracy of commutation and achieved brushless DC motor directly commutating without position sensor control.Through theoretical analysis, it is concluded that the voltage change of the nonconduction phase and conducted indepth research after experiments and research, the feasibility of the method was verified.
Key words: brushless DC motor; no position sensor control; nonconduction phase voltage; direct commutation

 

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码