关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:多极少槽电梯用永磁同步电机的优化分析
作者:黄金霖,曹光华,曾剑
2016年第2期 访问次数:243次

摘要:电梯是高层建筑必不可少的设备,其拖动系统成为人们研究的对象。本文在研究永磁同步电机的基础上,提出60槽58极和70槽20极两种不同极槽配合的电梯用永磁同步电机,分析两种电机的空载反电势、齿槽转矩,在此基础上,对两种电机的相关损耗进行分析,得出60槽58极永磁同步电机具有齿槽转矩小、损耗小、效率高等优点,在电梯中可得到广泛的应用。
关键词:极槽配合;电梯;损耗;齿槽转矩
Abstract: Elevator′s driving system was researched as a essential equipment in highrise building. Based on the study of permanent magnet synchronous motor, two different pole slot(60 slots 58 poles and 70 slots 20 poles) coordination of permanent magnet synchronous motor which used in elevator were proposed. The load back EMF, cogging torque were analyzed, on this basis, the related loss of the two motors were discussed. The results show that the permanent magnet synchronous motor with 60 slots 58 pole has the advantages such as small cogging torque, low loss and high efficiency, is very suitable applied in the elevator.
Key words: more pole and less solt; lift;loss; cogging torque

 

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码