关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:基于音圈直线电机的非圆车削加工进给系统研究
作者:艾 武,段 春
2012年第2期 访问次数:235次

摘  要:以中凸变椭圆活塞为例,研究了非圆截面零件的车削加工成形原理,在分析了加工过程中对刀具进给的要求的基础上,设计了以音圈直线电机直接驱动刀具的伺服进给系统,并实现了高速往复运动控制,最后在搭建的试验平台上模拟加工椭圆横截面,试验结果验证这套进给系统方案是可行的。
关键词:音圈直线电机;伺服控制;非圆车削;进给系统

Abstract: Taking the piston which has a middle-convex shape and variable ellipticity for example, the principle of shaping noncircular accessory using turning machine was studied. Based on the analysis of qualifications of the tool feeding system, the tool servo feeding system directly driven by a voice coil linear actuator was designed, and it could realize reciprocating motion control at a high speed. Simulation of machining ellipse cross section was accomplished on the platform built for testing, and the testing results indicate the feeding system is practicable.
Key words:
voice coil linear actuator; servo control; noncircular turning; feeding system

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码