关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:基于负压关断和栅极箝位的IR2110驱动电路的设计与研究
作者:陈 翀,程良伦,管 梁
2012年第11期 访问次数:244次

摘  要:对于采用桥式驱动集成芯片IR2110作为IGBT驱动的逆变器,存在着各桥臂驱动信号相互干扰的问题,严重时甚至会导致上下桥臂直通,造成短路的现象。针对上述问题,文中对IGBT驱动电路的抗干扰技术作了具体分析,提出了关断时负压和栅极电平箝位两种有效的抗干扰方法。经实验验证,这两种方法都可以有效的解决IGBT驱动信号的干扰问题,保证整个逆变系统的稳定工作。
关键词:IR2110;逆变器;箝位;负压
Abstract:  For the inverter which used bridge type driving integrated chips IR2110 as the IGBT driver, there was a problem that the bridge drive signals interfered with each other and when the problem is serious it would lead to the upper and lower switch through or short-circuit. According to the above problems, this paper made a detailed analysis in the IGBT driver circuit for anti-jamming technology, proposed two effective anti-jamming methods:turn-off negative voltage circuit and a gate-level clamp circuit. Experimental testing that both methods can effectively solving the interference problem of IGBT drive signals and ensuring the stability of the entire inverter system.
Key words:  IR2110; inverter; clamp; negative voltage
 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码