关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:基于试验设计方法的无刷直流电机结构优化设计
作者:洪兴华
2015年第9期 访问次数:278次

摘要:齿槽转矩是永磁电机的固有现象,造成电机转矩脉动,影响电机的在速度控制系统中的低速性能和位置控制系统中的高精度定位。本文利用响应面法对无刷直流电机的结构进行优化,抑制其齿槽转矩,从而提高控制系统性能。以一台4极6槽无刷直流电机作为研究对象,采用试验设计方法筛选电机各结构参数,得到电机齿槽转矩与主要结构参数之间的数学模型,计算出可使齿槽转矩最小的结构参数最优组合,并通过有限元方法验证计算结果的正确性。实验结果表明,优化后的无刷直流电机的齿槽转矩有效减少了90%,试验设计方法是可以迅速求得全局最优解的有效的电机优化方法。
关键词:无刷直流电机;齿槽转矩;试验设计方法;优化设计
Abstract: The output torque ripple of the permanent magnet (PM) motor due to the cogging torque has effects on the low-speed capacity in the speed control system and the high accuracy location in the position control system. In this paper the structure of a brushless direct current (BLDC) motor was optimized with the design of experiments (DOE) method to reduce the cogging torque and improve the capacity of control system. Taking a 4-pole 6-slot BLDC machine for example, the structure parameters were filtrated with DOE method and the numerical model of the cogging torque and main structure parameters was established to calculate the optimal combination for minimum cogging torque, which was validated by finite element method (FEM). The results show that the optimized cogging torque of the BLDC machine is effectively reduced by 90% and the DOE method is a fast and valid optimization method for searching the global optimal solution.
Key words: BLDC motor;cogging torque;DOE;optimal design
 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码