关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:基于观测器的火炮伺服控制系统故障检测
作者:黄 勇,毛 军,东 海,等
2012年第11期 访问次数:213次

摘  要:基于观测器的故障诊断方法,是基于观测对象数学模型可以确定的一种故障诊断方法。当伺服控制系统出现传感器、执行器或控制电路故障或失效,在观测器观测误差中会叠加一故障向量,使得观测误差不为0,则可判断控制系统发生故障。采用该方法对火炮伺服控制系统进行实时监控,对于提高火炮伺服控制系统可靠性和智能性具有现实意义。本文以一典型火炮伺服控制电路为例,求取了其故障观测器各参数,并建立了Matlab/simulink电路模型。仿真验证表明:通过观测器的观测误差对伺服控制系统运行状态进行实时监控和故障诊断,是行之有效的方法。
关键词:故障;观测器;伺服控制;误差

Abstract:  Fault diagnose based on observers is an approach which is based on certain math mode of observed object. When fault or invalidation of servo controlled system happens in its transducer, actuator and controlled circuit, fault vector can superimposed in the observed error, so that this error is not equal to 0 and can determine that the controlled system have a fault. Carry real time monitoring out by adopting this approach, which has a realistic significance on improving reliability and intelligence of gun servo controlled system. The author took a typical servo controlling system for example, and calculated parameters of fault observer, and set Matlab/Simulink circuit mode up. Simulation shows that this approach is effective.
Key words:  fault; observer; servo control; error

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码