关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:基于比例谐振的无刷直流电机电流规划控制
作者:谭博,申科,王西坡,等
2018年第12期 访问次数:258次

摘要:在三相六状态模式下工作的BLDCM存在较大的换相转矩脉动,采用电机反电势对电流波形进行规划的控制方法可以减小该转矩脉动。然而由于绕组电感的存在,会引起相电流滞后该相反电势的现象,从而导致电机相电流有效值和转矩脉动的增加。论文提出一种基于比例谐振的电流规划控制方法。该方法根据规划电流轨迹的傅里叶展开,采用基于比例谐振的电流环分别实现对电流基波和主要高次谐波的控制。最后,仿真结果表明所提出的方法可以减小相电流的滞后角度,抑制转矩脉动和减小电机铜耗。
关键词:无刷直流电机;电流规划;比例谐振控制;转矩脉动
Abstract: The brushless DC motor (BLDCM) operating in the three-phase six-state mode has a large commutation torque ripple, and the current planning control according to the back EMF of BLDCM can reduce the torque ripple. However, the BLDCM winding inductances cause the phase current to lag behind the back EMF, resulting in an increase of the phase current and torque ripple. The paper proposed a current planning control method based on proportional resonance (PR) control. According to the Fourier expansion of the planned current trajectory, the method used PR controller to control the current fundamental wave and the main higher harmonics, respectively. Finally, the simulation results show that the proposed method can reduce the lag angle of phase current, suppress torque ripple and reduce the copper loss.
Key words: BLDCM; current planning; proportionalresonant control; torque ripple
 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码