关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:基于死区补偿的电机低速运行稳定性研究
作者:杨武盖
2014年第11期 访问次数:249次

摘要:电机低速运行时,死区效应可能导致电流波形畸变严重,使电机转矩发生脉动。本文提出一种新型PWM控制死区补偿方法,该控制算法通过坐标变换、定标的方式将合成电流空间矢量与定子旋转磁场同步,根据电流空间矢量在旋转磁场中的位置分别对逆变器三相桥臂的导通时间进行补偿,其补偿时间的大小根据相应的电流的大小决定,确保扰动电压矢量同电流矢量旋转同步。Matlab仿真及实验结果表明该方法具有良好的性能和应用价值。

关键词:死区补偿;低速;稳定性;扰动电压矢量
Abstract: When motor runs at low speed, the dead zone may lead to larger current waveform distortion, and the motor torque ripple. This paper put forward a new kind of dead zone compensation method about PWM control. The control algorithm by means of coordinate transformation and selection was determined synthesis current space vector on the stator rotating magnetic field, and then according to the position of the current space vector in the rotating magnetic field of three-phase inverter bridge arm respectively conduct time compensation, its compensation time according to the size of the corresponding current the size of the decision, so that the disturbance voltage vector synchronization with current vector rotation. The Matlab simulation and experimental results show this method has good performance and applicable value.

Key words: dead zone compensation;low speed;stability;vector of disturbance voltage

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码