关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:基于模糊PI控制的PMSM位置伺服系统仿真
作者: 王翔,马瑞卿,吉攀攀
2010年第3期  访问次数:221次

摘  要:本文在分析了永磁同步电机(PMSM)数学模型的基础上,在Matlab的Simulink环境下构建了隐极式永磁同步电机位置伺服系统的仿真模型。控制系统采用经典的三闭环结构,其中电流环采用id=0的矢量控制策略,速度环采用PI控制,位置环采用模糊PI自适应控制,自适应控制通过Matlab软件编程。文中给出了系统各模块仿真模型的建立方法,并针对工程系统实际参数,进行了负载突加突卸时位置、速度和转矩瞬态过程仿真与分析。结果表明,该系统抗干扰性好,能快速准确地跟踪位置及转速给定。
关键词:永磁同步电机;矢量控制;模糊控制;建模;仿真


Abstract: In this paper,the mathematic model of the permanent magnet synchronous motor(PMSM)was analyzed first,and then the simulation model of the nonsalientpole PMSM was established in the simulink of the Matlab  based on the mathematic model of the PMSM.The control system adoped the classical three-close-loop structure.In this control system,the id=0 control strategy in current loop and PI control were used in speed loop,and also the fuzzy PI control in position loop which was realized by programming in the Matlab.Given the way of establishing the simulink model of every module in the Matlab given in this paper,and the transient processes of position,speed and torque were simulated and analyzed for the actual parameters of system project at the time of sudden loadadd/unload.The simulation results,show the system is of good antiinterference and able to track the given position and speed quickly and accurately.
Key Words: Permanent magnet synchronous motor (PMSM);Vector control;Fuzzy control;Modeling;Simulation

 

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码