关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:同步磁阻电机分析与设计(九)
作者:沈建新,蔡顺,袁赛赛,等
2017年第2期 访问次数:250次

摘要:本文分析电机加工与装配过程中可能引入的误差,以及这些误差对同步磁阻电机性能的影响。针对一台优化过的同步磁阻电机,分别讨论冲片冲制产生的毛刺、冲制边缘材料损坏、叠压自扣片、铆接错位以及定转子装配偏心等对电机平均转矩、转矩脉动、效率以及单边磁拉力的影响。分析电机加工工艺的误差对电机性能的影响,从而总结同步磁阻电机加工过程中需要严格控制偏差的工艺。
关键词:同步磁阻电机;加工;装配;自扣片;偏心

Abstract: Effect of the manufacturing and assembling imperfectness on the performance of synchronous reluctance machine (SynRM) was analyzed in this paper. Based on an optimized SynRM, the influence of the punching burrs, material partial damage caused by punching, interlocking dowels, riveting errors and the eccentricity of stator and rotor on the average torque, torque ripple, efficiency and radio force was detailed. Through the analysis of these influence, this paper concluded the processing techniques which should be controlled strictly during the manufacturing and assembling of the SynRM.
Key words: synchronous reluctance machine; manufacturing; assembling; stack interlocking dowel; eccentricity

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码