关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:不均匀气隙异步起动永磁同步电动机的设计及研究
作者:范乐,任宁宁
2015年第7期 访问次数:257次

摘要:本文设计了一台额定功率为22 kW-6P的异步起动永磁同步电动机。采用减小定子冲片槽口尺寸及不均匀气隙的方式,减小了电机的转矩波动,使气隙磁密波形正弦化,降低了气隙中磁密谐波的含量,电机的磁路更加合理。最后对电机的空载及负载特性进行了有限元分析,有限元分析及试验结果表明,该设计方案较合理,电机的各项性能指标满足设计要求。
关键词:异步起动永磁同步电动机;转矩波动;特性;气隙磁密;谐波
Abstract: This paper presented a rated power of 22 kW6P the linestart PMSM.By reducing the stator punching notch size and non uniform air gap way, reduced the torque ripple,the air gap magnetic flux density waveform more sinusoidal, and reduced content of flux density harmonics in the air gap, the magnetic circuit of the motor is more reasonable.Finally, the finite element analysis was done on the characteristics of the motor noload and load. Finite element analysis and experimental results show that, the design is reasonable. The characteristics of motor to meet the design requirements.
Key words: linestart PMSM; torque ripple; characteristic; air gap flux density; harmonic
 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码