关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:不同层数集中绕组永磁电机转子损耗研究
作者:刘福贵,杨凯,赵志刚,等
2019年第10期  访问次数:274次

摘要:由于转子散热条件差,过高的转子损耗会导致永磁体的不可逆热退磁,基于电磁场有限元分析软件Maxwell研究了不同层数36槽42极表贴式分数槽集中绕组永磁电机在最佳电流控制条件下的转子损耗,并且研究了最高转速为6000 r/min时永磁体圆周分段和转子dq轴开槽对转子损耗的影响。研究发现,随着绕组层数的增加,电机的转子损耗降低,但是电机的出力减小;并且永磁体圆周分段较转子dq轴开槽更有利于降低转子的损耗。
关键词:分数槽集中绕组;表贴式永磁电机;有限元分析;转子损耗
Abstract: Due to the poor heat dissipation condition of the rotor, excessive rotor loss will lead to irreversible thermal demagnetization of permanent magnets. The rotor losses of a 36slot 42pole surfacemounted fractionalslot concentratedwinding permanent magnet motor with different layers under optimal current control were studied based on the finite element analysis software Maxwell. The influence of the circumferential segment of permanent magnet and the slotting of dq axis on the rotor loss at the maximum speed of 6000 r/min was also studied. It is found that with the increase of winding layers, the rotor loss decreases, but the output of the motor decreases; and the circumferential segment of the permanent magnet is more conducive to reducing the rotor loss than the slotting of the dq axis of the rotor.
Key words: fractional slot concentrated winding;surface mounted permanent magnet motor;finite element analysis;rotor losses
 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码