关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:“一”型磁钢永磁电机空载漏磁系数计算
作者:公超,刘景林,胡晓杰,等
2015年第10期 访问次数:247次

摘要:永磁电机漏磁系数与永磁体宽度、电枢轴向长度、气隙大小和槽宽等参数密切相关,在电机的设计与分析中具有重要意义。而工程中,一般凭经验选取,带来较大误差。为得到较为准确的漏磁系数,首先采用磁路分析的方法得到了“一”形磁钢永磁电机的等效磁路,计算出各磁路部分的磁导,进而推导出漏磁系数计算公式;然后利用有限元分析软件建立了电机二维磁场仿真模型,得出较为准确的漏磁系数;接着通过比较两种方法得到的漏磁系数,校正磁路计算公式,得到较为准确的计算公式,最后对校正后的公式进行了验证。
关键词:漏磁系数;“一”形磁钢;磁路分析;有限元分析

Abstract: The leakage coefficient of permanent magnet motor which is closely related to the width of magnet, the axial length of armature, the size of air gap and the size of slot, etc.is very important to the motor design and analysis.  Nevertheless, it is usually selected according to designers′ experience which leads to great error. In order to get the more accurate formula to calculate leakage coefficient, firstly, the equivalent magnetic circuit of the permanent magnet motor was determined and the leakage permeability for every part of the motor was calculated with the method of magnetic circuit analysis. Then a more accurate leakage coefficient result was determined by establishing a dimensional magnetic field simulation model in finite element analysis (FEA) software. Next, compared the results obtained by the two methods and correct the formula to make it more accurate. Finally, the formula was validated.
Key words: leakage coefficient; “一” type magnet; magnetic circuit analysis; finite element analysis

 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码