关键字
协会热线:029-84276641
            首页微电机期刊
 
  综述
  伺服与控制
  设计与研究
  专题讲座
  检测技术
  工艺技术
  经验交流
  实用技术
  读者园地
  技术交流
  使用与维护
  标准评述
  工艺与装备
  驱动与控制
  应用研究
  测试研究
  精品连载
 
标题:LB2型离心泵用电动机结构的改进设计
作者:刘伟,高贵锋,彭庆,等
2016年第10期 访问次数:240次

摘要:针对LB2型离心泵存在的在额定工况下功率超高原因分析,提出在电动机支撑轴承轴向增加波形弹簧,并通过设定波形弹簧预紧力的方法解决了电动机轴向窜动量过大引起离心泵功率超高的问题。改进后现场试用效果良好,解决了离心泵在额定工况下功率超高、压力不稳的问题,为离心泵用电动机轴向窜动量的设计提供了一种通用的、定量的新方法。
关键词:离心泵;轴向窜动量;电动机;功率超高;波形弹簧
Abstract: Analysis on the problem of the high power of LB2 type centrifugal pump under the rated condition,put forward that the wave spring was added in the axial direction of the motor support bearing, and the problem of the high power of the centrifugal pump was solved by setting the pre tightening force of the wave spring.After the improvement, the trial effect is good, solves the problem of pressure unstable, high power under rated condition of centrifugal pump, a general and quantitative new design method was proposed for the motor of centrifugal pump with axial runout.
Key words: centrifugal pump;Axial channeling;motor;high power;wave spring
 
 
 
    广告服务 |   商务合作 |   使用帮助 |   网站地图 |     主办:中国电器工业协会微电机分会      挂靠:西安微电机研究所有限公司      地址:西安市高新区上林苑四路36号(710117)
   copyright © www.china-micromotor.com.cn all rights reserved.     版权所有:微电机网     陕ICP备05005551号-2
 

西安微电机研究所有限公司公众平台
二维码

《微电机》杂志公众平台二维码